Users Guide

For the new quad port prole conguration to take eect, you must rst save changes and then reload the switch.
Example
Dell(conf)#stack-unit 1 port 24 portmode quad
Warning: Enabling quad mode on stack-unit 1 port 24. Please verify whether the
configs related to interface Fo 1/24 are cleaned up before proceeding further.
[confirm yes/no]:yes
Dell(conf)#00:02:24: %STKUNIT1-M:CP %IFMGR-5-DYNAMIC_FANOUT: Port 24 in slot 1
has been fanned-out >>>>>
Dell(conf)#00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP
inserted in slot 1 port 24/2
00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP inserted in
slot 1 port 24/3
i00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP inserted in
slot 1 port 24/4
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q tag status
and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the interface information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port
/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a backup interface for this interface, enter the keyword backup.
NOTE: This command also enables you to view information corresponding to a
range of ports.
• For physical interfaces, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
• For port–channel interfaces, you can specify multiple ports as port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces port—channel 1 - 4.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit then the stack member number.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
Interfaces 709