Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
The shutdown command marks a physical interface as unavailable for trac. To discover if an interface is
disabled, use the show ip interface brief command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes dierent behavior. When a VLAN is disabled, the Layer 3 functions
within that VLAN are disabled. Layer 2 trac continues to ow. Entering the shutdown command on a port
channel disables all trac on the port channel and the individual interfaces within the port channel. To enable a
port channel, enter no shutdown on the port channel interface and at least one interface within that port
channel.
The shutdown and description commands are the only commands that you can congure on an interface
that is a member of a port channel.
Related Commands
• interface port-channel — create a port channel interface.
• interface vlan — create a VLAN.
• show ip interface — display the interface routing status. Add the keyword brief to display a table of
interfaces and their status.
speed (for 10/100/1000/10000 interfaces)
Set the speed for 10/100/1000/10000 interfaces. Set both sides of a link to the same speed (10/100/1000/10000) or to auto or the link
may not come up.
Syntax
speed {10 | 100 | 1000 | 10000 | auto}
To return to the default setting, use the no speed {10 | 100 | 1000 | 10000} command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
718 Interfaces