Users Guide

channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Parameters
interface (OPTIONAL) Enter any of the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Defaults Not congured.
Command Modes INTERFACE PORTCHANNEL
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Usage Information
Use the interface port-channel command to access this command.
You cannot add an interface to a Port Channel if the interface contains an IP address in its conguration. Only the
shutdown, description, mtu, and ip mtu commands can be congured on an interface if it is added to a
Port Channel. The
mtu and ip mtu commands are only available when the chassis is in Jumbo mode.
Interfaces 725