Users Guide

A value of 0 indicates to the host that the RDNSS address should not be used. You must
specify a lifetime using the lifetime or infinite parameter.
innite Enter the keyword infinite to specify that the RDNSS lifetime does not expire.
Defaults Not Congured
Command Modes INTERFACE CONFIG
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.0) Introduced on the Z9000, S6000, S4810, S4820T, and MXL..
Usage Information Use this command to add, edit, or delete an IPv6 RDNSS address and lifetime value. You can congure up to four
IPv6 RDNSS addresses. You must specify a lifetime using the lifetime or innite parameter.
Example
Dell(conf-if-te-1/1/1)# ipv6 nd dns-server 1000::1 1
ipv6 route
Establish a static IPv6 route.
Syntax
ipv6 route [vrf vrf-name] ipv6-address prefix-length {ipv6-address | interface
| interface ipv6-address} [distance] [tag value] [permanent] [weight weight-
value]
To remove the IPv6 route, use the no ipv6 route command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to install IPv6 routes in
that VRF.
ipv6-address prex-
length
Enter the IPv6 address in the x:x:x:x::x format then the prex length in the /x format. The
range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
810 IPv6 Basics