Users Guide

Version Description
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.2.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
When the interface goes down, Dell Networking OS withdraws the route. The route is re-installed, by Dell
Networking OS, when the interface comes back up. When a recursive resolution is “broken,” Dell Networking OS
withdraws the route. The route is re-installed, by Dell Networking OS, when the recursive resolution is satised.
After an IPv6 static route interface is created, if an IP address is not assigned to a peer interface, the peer must be
manually pinged to resolve the neighbor information.
You can specify a weight for an IPv4 or IPv6 static route. If the weight value of a path is 0, then that path is not
used for forwarding when weighted ECMP is in eect. Also, if a path corresponding to a static route (destination)
has a non-zero weight assigned to it and other paths do not have any weight congured, then regular ECMP is
used for forwarding.
You can specify the weight value only to destination address and not on the egress port.
A route is considered for weighted ECMP calculations only if each paths corresponding to that route is congured
with a weight.
Example
Dell(conf)# ipv6 route 44::/64 33::1 weight 100
Dell(conf)# ipv6 route 44::/64 33::2 weight 200
Dell(conf)# do show running-config | grep ipv6 route
Dell(conf)# ipv6 route vrf vrf_test 44::/64 33::1 weight 100
Dell(conf)# ipv6 route vrf vrf_test 44::/64 33::2 weight 200
Dell(conf)# do show running-config | grep ipv6 route vrf
Related Commands
• show ipv6 route — view the IPv6 congured routes.
show ipv6 management-route
Display the IPv6 static routes congured for the management interface.
Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all Management
interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly connected to
the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number of active
and non-active routes and their sources.
812 IPv6 Basics