Service Manual

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to clear the
neighbor corresponding to that VRF.
NOTE: If you do not specify this option, the neighbors in the default VRF are
cleared.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format to remove a specific
IPv6 neighbor.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
interface
interface
To remove all neighbor entries learned on a specific interface, enter the keyword
interface then the interface type and slot/port or number information of the
interface:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
debug ipv6 nd ra-guard
Enable debugging for IPv6 RA guard snooping information.
Syntax
debug ipv6 nd ra-guard [interface_type slot/port | count value]
Parameters
interface_type
slot/port
Enter the one of the following interfaces and slot/port information:
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
count value Enter the keyword count then the number of debug outputs. The range is from 1
to 65534. The default is infinity.
Defaults None
Command Modes EXEC Privilege
Neighbor Discovery Protocol (NDP) 843