Users Guide

Dell(conf-if-te-1/26/1)#?
end Exit from configuration mode
exit Exit from interface configuration mode
Dell(conf-if-te-1/26/1)#exit
Dell(conf)#
Dell(conf)#line ?
console Primary terminal line
vty Virtual terminal
Dell(conf)#line vty 0
Dell(config-line-vty)#exit
Dell(conf)#
Applying a Privilege Level to a Username
To set the user privilege level, use the following command.
• Congure a privilege level for a user.
CONFIGURATION mode
username username privilege level
Applying a Privilege Level to a Terminal Line
To set a privilege level for a terminal line, use the following command.
• Congure a privilege level for a user.
CONFIGURATION mode
username username privilege level
NOTE
: When you assign a privilege level between 2 and 15, access to the system begins at EXEC mode, but the prompt is
hostname#, rather than hostname>.
Conguring Logging
The Dell Networking OS tracks changes in the system using event and error messages.
By default, Dell Networking OS logs these messages on:
• the internal buer
• console and terminal lines
• any congured syslog servers
To disable logging, use the following commands.
• Disable all logging except on the console.
CONFIGURATION mode
no logging on
• Disable logging to the logging buer.
CONFIGURATION mode
no logging buffer
• Disable logging to terminal lines.
CONFIGURATION mode
no logging monitor
Management
59