Users Guide

• SYN
• PSH
• RST
• URG
In the existing software, ECE/CWR TCP ag qualiers are not supported.
• Because this functionality forcibly marks all the packets matching the specic match criteria as ‘yellow’, Dell Networking OS does not
support Policer based coloring and this feature concurrently.
• If single rate two color policer is congured along with this feature, then by default all packets less than PIR would be considered as
“Green” But ‘Green’ packets matching the specic match criteria for which ‘color-marking’ is congured will be over-written and
marked as “Yellow”.
• If two rate three color policer is congured along with this feature then,
• x < CIR – will be marked as “Green”
• CIR < x< PIR – will be marked as “Yellow”
• PIR < x – will be marked as “Red”
But ‘Green’ packets matching the specic match criteria for which ‘color-marking’ is congured will be over-written and marked as “Yellow”.
Create a QoS Policy
There are two types of QoS policies — input and output.
Input QoS policies regulate Layer 3 and Layer 2 ingress trac. The regulation mechanisms for input QoS policies are rate policing and
setting priority values.
• Layer 3 — QoS input policies allow you to rate police and set a DSCP or dot1p value. In addition, you can congure a drop precedence
for incoming packets based on their DSCP value by using a DSCP color map. For more information, see DSCP Color Maps.
• Layer 2 — QoS input policies allow you to rate police and set a dot1p value.
Output QoS policies regulate egress trac. The regulation mechanisms for output QoS policies are bandwidth percentage, scheduler strict,
rate shaping and WRED.
NOTE
: When changing a "service-queue" conguration in a QoS policy map, all QoS rules are deleted and re-added automatically
to ensure that the order of the rules is maintained. As a result, the Matched Packets value shown in the show qos
statistics command is reset.
NOTE: To avoid issues misconguration causes, Dell Networking recommends conguring either DCBX or Egress QoS features,
but not both simultaneously. If you enable both DCBX and Egress QoS at the same time, the DCBX conguration is applied and
unexpected behavior occurs on the Egress QoS.
Creating an Input QoS Policy
To create an input QoS policy, use the following steps.
1 Create a Layer 3 input QoS policy.
CONFIGURATION mode
qos-policy-input
Create a Layer 2 input QoS policy by specifying the keyword layer2 after the qos-policy-input command.
2 After you create an input QoS policy, do one or more of the following:
690
Quality of Service (QoS)