Users Guide

192.161.1.0/24 auto-summary
192.162.3.0/24
[120/1] via 29.10.10.12, 00:01:22, Fa 1/4
192.162.3.0/24 auto-summary
Dell#show ip rip database
Total number of routes in RIP database: 978
160.160.0.0/16
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
160.160.0.0/16 auto-summary
2.0.0.0/8
[120/1] via 29.10.10.12, 00:01:22, Fa 1/49
2.0.0.0/8 auto-summary
4.0.0.0/8
[120/1] via 29.10.10.12, 00:01:22, Fa 1/49
4.0.0.0/8 auto-summary
8.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
8.0.0.0/8 auto-summary
12.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
12.0.0.0/8 auto-summary
20.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
20.0.0.0/8 auto-summary
29.10.10.0/24 directly connected,Fa 1/49
29.0.0.0/8 auto-summary
31.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
31.0.0.0/8 auto-summary
192.162.2.0/24
[120/1] via 29.10.10.12, 00:01:21, Fa 1/49
192.162.2.0/24 auto-summary
192.161.1.0/24
[120/1] via 29.10.10.12, 00:00:27, Fa 1/49
192.161.1.0/24 auto-summary
192.162.3.0/24
[120/1] via 29.10.10.12, 00:01:22, Fa 1/49
192.162.3.0/24 auto-summary
To disable RIP globally, use the no router rip command in CONFIGURATION mode.
Congure RIP on Interfaces
When you enable RIP globally on the system, interfaces meeting certain conditions start receiving RIP routes.
By default, interfaces that you enable and congure with an IP address in the same subnet as the RIP network address receive RIPv1 and
RIPv2 routes and send RIPv1 routes.
Assign IP addresses to interfaces that are part of the same subnet as the RIP network identied in the network command syntax.
Controlling RIP Routing Updates
By default, RIP broadcasts routing information out all enabled interfaces, but you can congure RIP to send or to block RIP routing
information, either from a specic IP address or a specic interface.
To control which devices or interfaces receive routing updates, congure a direct update to one router and congure interfaces to block
RIP updates from other sources.
To control the source of RIP route information, use the following commands.
• Dene a specic router to exchange RIP information between it and the Dell Networking system.
ROUTER RIP mode
718
Routing Information Protocol (RIP)