Service Manual

interface TenGigabitEthernet 2/7/1
no ip address
shutdown
!
interface TenGigabitEthernet 2/8/1
no ip address
shutdown
!
interface TenGigabitEthernet 2/9/1
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the congurations applied on an interface to its factory default state. To reset the conguration, perform the following steps:
1 View the congurations applied on an interface.
INTERFACE mode
show config
Dell(conf-if-te-1/5/1)#show config
!
interface TenGigabitEthernet 1/5/1
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
Dell(conf)#default interface tengigabitethernet 1/5/1
3 Verify the conguration.
INTERFACE mode
show config
Dell(conf-if-te-1/5/1)#show config
!
interface TenGigabitEthernet 1/5/1
no ip address
shutdown
All the applied congurations are removed and the interface is set to the factory default state.
Enabling a Physical Interface
After determining the type of physical interfaces available, to enable and congure the interfaces, enter INTERFACE mode by using the
interface interface command.
1 Enter the keyword interface then the type of interface and slot/port[/subport] information.
CONFIGURATION mode
interface interface
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
2 Enable the interface.
342
Interfaces