Service Manual

INTERFACE mode
no shutdown
To conrm that the interface is enabled, use the show config command in INTERFACE mode. To leave INTERFACE mode, use the
exit command or end command. You cannot delete a physical interface.
Physical Interfaces
The Management Ethernet interface is a single RJ-45 Fast Ethernet port on a switch.
The interface provides dedicated management access to the system.
Stack-unit interfaces support Layer 2 and Layer 3 trac over the 10-Gigabit Ethernet and 40-Gigabit Ethernet interfaces. These interfaces
can also become part of virtual interfaces such as virtual local area networks (VLANs) or port channels.
For more information about VLANs, refer to Bulk Conguration. For more information on port channels, refer to Port Channel Interfaces.
Dell Networking OS Behavior: The system uses a single MAC address for all physical interfaces.
Conguration Task List for Physical Interfaces
By default, all interfaces are operationally disabled and trac does not pass through them.
The following section includes information about optional congurations for physical interfaces:
• Overview of Layer Modes
• Conguring Layer 2 (Data Link) Mode
• Conguring Layer 2 (Interface) Mode
• Management Interfaces
• Auto-Negotiation on Ethernet Interfaces
• Adjusting the Keepalive Timer
• Clearing Interface Counters
40G to 1G Breakout Cable Adaptor
As a default conguration, you can see the speed CLI with 10M, 100M and 1000M options for all the front-end interfaces. By default, the
show config command does not display the default speed. If you change the speed to 100 and then to 1000, it is displayed in the show
config output or if you OIR 10G port with speed 1000 with 40G to 1G cable, it displays the default speed.
You can use the speed command only to congure on the management optic ports alone. Without any optic, if you congure the speed,
the conguration is assigned as the port speed to support Provisioning through BMP.
User viewable Logs:
Logs for optic insertion and removal are same as QSFP optics. You can use the show inventory media command to check the optic
type and the
show interface transceiver command to view the optic properties.
show inventory media
0 88 QSFP 4x1000BASE-T US0XJYD04162059 Yes
0 89 QSFP 4x1000BASE-T US0XJYD04162059 Yes
0 90 QSFP 4x1000BASE-T US0XJYD04162059 Yes
0 91 QSFP 4x1000BASE-T US0XJYD04162059 Yes
show interface transceiver
QSFP 0 Serial ID Base Fields
QSFP 0 Id = 0x0d
QSFP 0 Ext Id = 0x00
QSFP 0 Connector = 0x0c
Interfaces
343