Service Manual
UDP Helper
User datagram protocol (UDP) helper allows you to direct the forwarding IP/UDP broadcast trac by creating special broadcast addresses
and rewriting the destination IP address of packets to match those addresses.
Congure UDP Helper
To congure Dell Networking OS to direct UDP broadcast, enable UDP helper and specify the UDP ports for which trac is forwarded. See
Enabling UDP Helper
Important Points to Remember
• The existing ip directed broadcast command is rendered meaningless if you enable UDP helper on the same interface.
• The broadcast trac rate should not exceed 200 packets per second when you enable UDP helper.
• You may specify a maximum of 16 UDP ports.
• UDP helper is compatible with IP helper (ip helper-address):
•
UDP broadcast trac with port number 67 or 68 are unicast to the dynamic host conguration protocol (DHCP) server per the ip
helper-address
conguration whether or not the UDP port list contains those ports.
• If the UDP port list contains ports 67 or 68, UDP broadcast trac is forwarded on those ports.
Enabling UDP Helper
To enable UDP helper, use the following command.
• Enable UPD helper.
ip udp-helper udp-ports
Example of Enabling UDP Helper and Using the UDP Helper show Command
Dell(conf-if-te-1/1/1)#ip udp-helper udp-port 1000
Dell(conf-if-te-1/1/1)#show config
!
interface TenGigabitEthernet 1/1/1
ip address 2.1.1.1/24
ip udp-helper udp-port 1000
no shutdown
To view the interfaces and ports on which you enabled UDP helper, use the show ip udp-helper command from EXEC Privilege
mode.
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
te 1/1/1 1000
Conguring a Broadcast Address
To congure a broadcast address, use the following command.
• Congure a broadcast address on an interface.
ip udp-broadcast-address
Examples of Conguring and Viewing a Broadcast Address
Dell(conf-if-vl-100)#ip udp-broadcast-address 1.1.255.255
Dell(conf-if-vl-100)#show config
IPv4 Routing
391










