Service Manual
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a port channel interface, enter the keywords port-channel then a
number.
direction {rx | tx |
both}
Enter the keyword direction then one of the packet directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving packets.
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.0.0 Added support for Source and destination.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell# monitor session 0
source Port-channel 10 destination TenGigabitEthernet 1/33/1 direction tx
1036
Port Monitoring