Service Manual

maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
Syntax maximum dynamic-routes limit {warn-threshold threshold-value | warning-only}
To remove the limit on the maximum number of routes used, use the no maximum dynamic-routes
command.
Parameters
limit Maximum number of routes allowed in a VRF. Valid range is from 1 to 16,000 (or
maximum allowable for that platform if smaller value).
warning-threshold Warning threshold value is expressed as a percentage of the limit value. When the
number of routes reaches the specied percentage of the limit, a warning message
is generated. Valid range is 1 to 100. When warn-threshold is used, once the limit is
reached, additional dynamic routes will not be allowed.
warning-only When the warning-only option is used, a syslog message will be thrown when
maximum number of dynamic routes reaches the limit. Additional dynamic routes
will still allowed.
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
Command Modes CONFIGURATION-VRF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OSCommand Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.4(0.0) Introduced on the S–Series.
Usage Information
If the maximum route limit is not specied for a VRF, then it has unlimited space that extends to the
maximum number of entries allowed for the system. This command is not applicable to the default and
management VRFs.
show ip vrf
Displays information corresponding to the VRFs that are congured in the system.
Syntax
show ip [vrf vrf-name]
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to display information
corresponding to that VRF..
Command Modes
EXEC
EXEC Privilege
1366
Virtual Routing and Forwarding (VRF)