Service Manual

• after a VLT device is reloaded.
• if the Peer VLT device was up at the time the VLTi link failed to the time when it was restored.
Related Commands show vlt statistics — displays statistics on VLT operations.
lacp ungroup member-independent
Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
Syntax
lacp ungroup member-independent {vlt | port-channel}
Parameters
port-channel Force all LACP port-channel members to become switchports.
vlt Force all VLT LACP members to become switchports.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added port-channel parameter on the S4810.
8.3.8.0 Introduced on the S4810.
Usage Information
LACP on the VLT ports (on a VLT switch or access device), which are members of the virtual link trunk, is
not brought up until the VLT domain is recognized on the access device.
On the S4810, during boot-up in a stacking conguration, the system must be able to reach the DHCP
server with the boot image and conguration image. During boot-up, only untagged DHCP requests are sent
to the DHCP server to receive an oer on static LAGs between switches. The DHCP server must be
congured to start in BMP mode. If switches are connected using LACP port-channels like the VLT peer and
Top of Rack (ToR), use the port-channel parameter on the ToR-side conguration to allow member ports of
an ungrouped LACP port-channel to inherit vlan membership of that port channel to ensure untagged
packets that are sent by a VLT peer device reach the DHCP server located on the ToR.
To ungroup the VLT and port-channel congurations, use the no lacp ungroup member independent
command on a VLT port channel, depending on whether the port channel is VLT or non-VLT.
Virtual Link Trunking (VLT)
1377