Service Manual
community-list-
name
Enter the name of a congured IP community list (maximum 140 characters).
exact-match Enter the keyword for an exact match of the communities.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The show ip bgp community-list command without any parameters lists BGP routes matching the
Community List and the output is the same as for the show ip bgp command output.
The following describes the show ip bgp community-list pass command shown in the following
example.
Field Description
Network Displays the destination network prex of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is listed in this column,
then local routes exist in the routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the destination network.
Example
Dell#conf t
Dell(conf)#ip community-list cl1
Dell(config-community-list)#permit 1000:1
Dell(config-community-list)#end
Dell#show ip bgp community-list cl1
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r -
redistributed
Border Gateway Protocol
359