Service Manual

Important Points to Remember
• All line cards/Stack Members within a single system must have the same UFT mode proles. this prole must match the system
UFT mode prole (the prole on the primary route processor module [RPM]/ Master Unit of the Stack).
• The UFT mode conguration is applied to the entire system when you use the CONFIGURATION mode commands. Save the
running-conguration to aect the change.
• You MUST save your changes and reboot the system for UFT mode proling to take eect.
hardware forwarding-table mode
Select a mode to initialize the maximum scalability size for L2 MAC table or L3 Host table or L3 Route table.
Syntax
hardware forwarding-table mode {scaled-l3- hosts | scaled-l3-routes}
Parameters
scaled-l3–
hosts
Enter the keyword scaled-l3–hosts to select the forwarding table mode for
scaling l3 host entries..
scaled-l3–
routes
Enter the keyword scaled-l3–routes to select the forwarding table mode for
scaling l3 route entries.
Defaults UFT mode 2
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000, S6000-ON, and Z9500 switch..
Usage Information This command takes eect only after reboot.
Related Commands show hardware forwarding-table mode — displays the hardware forwarding table mode in the current boot
and in the next boot.
show hardware forwarding-table mode
Display the hardware forwarding table mode in the current boot and in the next boot.
Syntax
show hardware forwarding-table mode
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000, S6000-ON, and Z9500 switch.
Example
Dell#show hardware forwarding-table mode
Current Settings Next Boot Settings
Mode : Default scaled-l3-hosts
396
Content Addressable Memory (CAM)