Service Manual

Example
Dell(conf)#interface range tengigabitethernet 1/1/1 - 1/1/2
Dell(conf-if-range-gi-1/1-1/1/2)#show config
!
interface TenGigabitEthernet 1/1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-gi-1/1-1/1/2)#
show interfaces
Display information on a specic physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
interface Enter one of the following keywords and slot/port[/subport] or number
information:
• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For stack-units, enter the keywords stack-unit then the slot/port
information. The range is from 0 to 11.
•
For a Null interface, enter the keyword null then the Null interface number.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the tunnel interface type.
9.1(0.0) Updated Management Ethernet output to include two global IPv6 addresses on
S4810 and Z9000 and added output example showing OpenFlow instance ID.
8.3.12.1 Updated command output to support multiple IPv6 addresses on S4810.
8.3.11.4 Output expanded to support eSR4 optics in Z9000.
594
Interfaces