Service Manual

Hardware is Force10Eth, address is 00:01:e8:4c:f2:83
Current address is 00:01:e8:4c:f2:83
!-------------output truncated ----------------!
Related Commands
show hardware stack-unit — displays data plane and management plane input/output statistics.
show interfaces — displays information on a specic physical interface or virtual interface.
show interfaces status
To display status information on a specic interface only, display a summary of interface information or specify a stack-unit slot and
interface.
Syntax
show interfaces [interface status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port[/subport] or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a Loopback interface, enter the keyword loopback then the slot/port
information. The range is from 0 to 16383.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Interfaces
603