Service Manual

stack-unit quad-port-prole
Syntax
stack-unit [stack-unit number] quad-port-profile [default|<1–32>]
To remove the quad-port conguration, use the [no] stack-unit[stack-unit number] quad-
port-profile [default|<1–32>]command syntax.
Parameters
stack-unit
number<1–32>
Enter the port number. The range is from 1 to 6.
The range of the default ports are separated by —,
Defaults 2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,27,29,31
Command Modes CONFIGURATION
Command History
Version 9.7(0.0) Introduced on the S6000 and S6000–ON.
Usage Information
The prole can only have 12-port groups in the rst 16 and last 16 groups. Any change in the prole needs
save and reload.
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q tag
status and VLAN membership.
Syntax
show interfaces switchport [interface | stack-unit unit-id ]
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port[/subport] or
number information:
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a backup interface for this interface, enter the keyword backup.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
606
Interfaces