Service Manual

rmdir
Removes a directory from the NFS mounted le system.
Syntax
rmdir nfsmount://mount-point/usrname
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.7(0.0) Introduced this command.
Example
Dell#rmdir nfsmount:/nfs-mountpoint/guest
Proceed to remove the directory [confirm yes/no]: yes
Dell#
Related Commands mkdir – creates a directory.
upgrade system
Upgrade the Dell Networking OS image. To upgrade the bootash or bootselector image, use the upgrade boot command.
Syntax
upgrade system {flash: | ftp: | nfsmount: | scp: | stack-unit {stack-unit-id | all} | tftp: | | usbflash:} file-url {A: |B:}
Parameters
system Enter the keyword system to upgrade the operating system (OS) image.
ash: le-url Enter the keyword flash: and specify the location of the image le in the format //directory-path or press Enter to launch a prompt sequence.
ftp: le-url Enter the keyword ftp: and specify the location of the image le in the format //userid:password@host-ip/filepath or press Enter to launch a prompt sequence.
nfsmount://
<mount-point>/
lepath
Enter the keyword nfsmount: and specify the location of the image le in the format //<mount-point>/filepath.
scp: le-url Enter the keyword scp: and specify the location of the image le in the format userid:password@host-ip/filepath or press Enter to launch a prompt sequence.
stack-unit stack-
unit-id
Enter the keyword stack-unit and specify the stack-unit ID to sync the image to that stack-unit.
stack-unit all Enter the keyword stack-unit followed by the keyword all to sync the image on all stack-units.
tftp: le-url Enter the keyword tftp: and specify the location of the image le in the format //host-ip/filepath or press Enter to launch a prompt sequence.
usbash: le-url Enter the keyword usbflash: and specify the location of the source le in the format //directory-path to upgrade form an external ash device or press Enter to launch a prompt sequence.
A: | B: Specify the ash partition of the operating-system image to be upgraded.
Defaults none
Command Modes EXEC Privilege
62
File Management