Service Manual

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.7(0.0) Added support for NFS mount.
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0(0.0) Added support for IPv6 for the file-url parameter.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000. Added support for the SSD on the Z9000 only.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added support for TFTP and SCP.
Version 7.6.1.0 Introduced on the S-Series.
Usage Information
RFC 3986 species that IPv6 host addresses in a uniform resource identier (URI) must be enclosed in square brackets, [X:X:X:X::X]. For maximum exibility this command accepts IPv6 host addresses with or without the square brackets.
After you upgrade the system image, by entering the command. specify the location where the Dell Networking OS image used to boot the system is stored (boot system), save the conguration to the start-up cong le (write memory), and reload the system (reload).
Example
Dell# upgrade system tftp://10.11.8.12/dv-rainier-13 a:
00:39:32 : Discarded 1 pkts. Expected block num : 51. Received block num: 50
!00:39:36 : Discarded 1 pkts. Expected block num : 65. Received block num: 64
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!..............................................................................................................................................................................................!
93924044 bytes successfully copied
System image upgrade completed successfully.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Image upgraded to all
rename
Rename a le in the local le system.
Syntax
rename url url
Parameters
url Enter the following keywords and a lename:
• For a le on the internal Flash, enter flash:// followed by the lename.
• For a le on an NFS mounted le system, enter nfsmount:// followed by the
mount point and le path.
•
For a le on an external USB drive, enter usbflash:// followed by the
lename.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
File Management
63