Service Manual

24
IPv6 Basics
IPv6 basic commands are supported on the Dell Networking OS.
NOTE: For information about the Dell Networking operating software version and platform that supports IPv6 in each
software feature, refer to the
IPv6 Addressing chapter of the Dell Networking OS Conguration Guide .
cam-ipv6 extended-prex
Enable LPM partitioning to support IPv6 /65 to /128 route prexes to be stored in Partition 1.
Syntax
cam-ipv6 extended-prefix <Max-IPv6-prefixes>
To remove LPM partitioning conguration, use no cam-ipv6 extended-prex.
Parameters
Max-IPv6-Prex Maximum number of IPv6 prexes in the mask length of /65 to /128. The possible
values are 1024, 2048, and 3072.
Defaults LPM is not partitioned with Partition 1 and therefore /65 to /128 prexes are not converted to /64 prexes
and are installed and saved in LPM. All the packets for those routes traverse through the default route path.
Command Modes CONFIGURATION
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S6000.
Usage Information You can partition the LPM table to store IPv6 prexes greater than /64 mask length. Requires reboot of the
switch to take eect as the SDK handles this only during its initialization.
clear ipv6 route
Clear (refresh) all or a specic route from the IPv6 routing table.
Syntax
clear ipv6 route [vrf vrf-name] {* | ipv6-address prefix-length}
692
IPv6 Basics