Service Manual

Version 8.3.11.1 Introduced on the Z9000. Added support for the SSD on the Z9000 only.

Version 8.3.7.0 Introduced on the S4810.

Version 7.7.1.0 Added support for TFTP and SCP.

Version 7.6.1.0 Introduced on the S-Series.

Usage Information

You must reload Dell Networking OS after executing this command.

Example

Dell#upgrade boot ?

all Upgrade both boot flash image and selector image

bootflash-image Upgrade boot flash image

bootselector-image Upgrade boot selector image

Dell#

verify

Validate the software image on the ash drive after the image has been transferred to the system, but before the image has been

installed.

Syntax verify { md5 | sha256 }[ flash:// ] img-file [hash-value]

Parameters

md5 Enter the md5 keyword to use the MD5 message-digest algorithm.

sha256

Enter the sha256 keyword to use the SHA256 Secure Hash Algorithm

ash:// (Optional). Enter the flash:// keyword. The default is to use the ash drive. You

can just enter the image le name.

img-le Enter the name the Dell Networking software image le to validate.

hash-value (Optional). Enter the relevant hash published on i-Support.

Defaults ash drive

Command Modes EXEC mode

Command History Version 9.5.(0.0)

Introduced on the Z9000, S6000, S4820T, S4810, MXL

Usage Information

You can enter this command in the following ways:

• verify md5 ash://img-le

• verify md5 ash://img-le <hash-value>

• verify sha256 ash://img-le

• verify sha256 ash://img-le <hash-value>

File Management