Service Manual

To exit OSPF for IPv6, use the no ipv6 router ospf process-id command.
Parameters
process-id
Enter the process identication number. The range is from 1 to 65535.
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to install IPv6
routes in that VRF.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
maximum-paths
Enable the software to forward packets over multiple paths.
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths command.
Parameters
number Specify the number of paths. The range is from 1 to 64. The default is 8 paths.
Defaults 8
Command Modes ROUTER OSPF
Command History
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.1 Introduced on the E-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)
985