Administrator Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the reload command, the system boots into the Dell Networking OS.
If there is a change in the running conguration, the system prompts you to save the new conguration when you
reload the system using the reload command. You can also save your running conguration manually using the
copy running-config command.
You can use the conditional parameter if any conguration changes made to the NVRAM, such as, stack-
group and fanout congurations, must be saved.
Example
The following example shows how to reload the system:
Dell# reload
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into Dell diagnostics mode:
Dell#reload dell-diag
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE mode:
Dell#reload onie
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE prompt and enter the install mode directly:
Dell#reload onie install
Proceed with reload [confirm yes/no]: yes
send
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
* Enter the asterisk character * to send a message to all tty lines.
line Send a message to a specic line. The range is from 0 to 11.
console Enter the keyword console to send a message to the primary terminal line.
vty Enter the keyword vty to send a message to the virtual terminal.
Defaults none
Command Modes EXEC
Control and Monitoring 121