Administrator Guide

ethertype | source-
dest-mac ]
• dest-module-id — Use dest-module-id eld in hash calculation.
• vlan — Use vlan eld in hash calculation .
• ethertype — Use Ethertype eld in hash calculation.
• source-dest-mac — Use SMAC and DMAC elds in hash calculation.
tunnel [ipv4-over-
ipv4 | ipv4-over-
gre-ipv4 | mac-in-
mac]}
To use tunnel key elds in hash computation, enter the keyword tunnel then one of the
parameters:
• ipv4-over-ipv4 — Use ipv4-over-ipv4 eld in hash calculation.
• ipv4-over-gre-ipv4 — Use ipv4-over-gre-ipv4 eld in hash calculation.
• mac-in-mac — Use mac-in-mac eld in hash calculation.
Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-port).
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
management route
Congure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ip-address mask | ipv6-address 1.1.1.1prefix-length}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet}
To remove a static route, use the no management route command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prex format) of the destination
subnet.
IPv4 Routing 787