Administrator Guide

brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces and
whether an IP address is assigned.
congured (OPTIONAL) Enter the keyword configured to display the physical interfaces with
non-default congurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Updated the command output to include the unicast reverse path forwarding (uRPF)
status.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series E600i.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip interface command shown in the following example.
Lines Description
TenGigabitEthernet
1/1...
Displays the interface’s type, physical and line protocol status.
Internet address... States whether an IP address is assigned to the interface. If an IP address is assigned,
that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the congured incoming access list. If none is congured, the phrase
“not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
800 IPv4 Routing