Install Guide

Figure 9. Four-post threaded conguration

2 Attach the front and rear anges for each rail to the post anges with two user-supplied screws at each end, item 2.

S6000-ON system installation

You can mount the system in the 1U front-rack, four-post or two-post congurations. The following is an example of a front-rack

conguration.

For the 1U two-post ush or center congurations, slide the system into the rails in the same manner as the four-post congurations.

Installing a 1U Front-Rack

You must congure the rails that are attached to the system.

1 Attach the switch rails (inner chassis members) to the S6000-ON system. The following illustration, item 3, shows the detail for the

front stando with the locking tab.

S6000–ON installation