Install Guide

Figure 13. PSU installation

1—PSU

2—Slot

When you install the PSU correctly, it snaps into place and is ushed with the back of the switch.

4 Plug in the appropriate AC three prong cord from the switch PSU to the external power source.

5 Repeat steps 1 through 4 if you have a second power supply using the second PSU slot on the S6000-ON system.

NOTE

: The S6000-ON powers up when the cables are connected between the power supply and the power source.

AC power supply replacement

CAUTION

: Disconnect the power cord before removing the power supplies. Also, disconnect all power cords before servicing.

NOTE: The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the S6000–

ON chassis.

NOTE: If a PSU fails, you must replace the entire unit. There are no eld serviceable components in the PSU. To request a

hardware replacement, see Technical Support.

NOTE: If you use a single PSU, install a blank plate in the other PSU slot. Dell EMC recommends using power supply 2 (PSU2) as

the blank plate slot.

Disconnect the power cable from the PSU.

2 Use the grab handle to slide the PSU out of the power supply bay.

3 Use the grab handle on the replacement PSU to slide it into the power supply bay.

4 Attach the power cord to the replacement PSU.

NOTE

: The system powers up when the cables are connected between the power supply and the power source.

26 Power supplies