Install Guide

• 8 data bits
• 1 stop bit
• No ow control
Accessing the Console Port
To access the console port, use the following steps.
1 Install the provided RJ-45 connector side of the provided copper cable into the S6000-ON console port.
2 Install the DB-9 female side of the provided copper cable into your PC’s serial port (or into other DTE terminal server hardware that
you intend to use).
3 Keep the default terminal settings on the S6000-ON console as follows:
• 115200 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No ow control
USB-B console port access
The terminal settings are the same for the USB-B port and the console port:
• 115200 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No ow control
When you connect the USB-B port, it becomes the primary connection and, when the system is connected, it sends all messages to the
USB-B port.
Figure 16. USB-B console port connector
1—USB-B Port
Management ports
31