Install Guide

Parameter Specications

1.4 A @ 280 watts/200vac

Maximum power consumption 286 Watts

Reliability MTBF 355,178 hours

IEEE standards

The S6000–ON complies with the following IEEE standards:

• 802.3ab Gigabit Ethernet (1000BASE-T)

• 802.3ae 10 Gigabit Ethernet (10GBASE-X)

• 802.3ba 40 Gigabit Ethernet (40GBase-SR4, 40GBase-CR4) on optical ports

• 802.3u Fast Ethernet (100BASE-TX)

• 802.3z Gigabit Ethernet (1000BASE-X)

Agency compliance

The S6000–ON is designed to comply with the following safety and agency requirements.

USA Federal Communications Commission (FCC) statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.

These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the

instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own

expense.

Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell Networking is not

responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized

changes or modications in the equipment. Unauthorized changes or modication could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Figure 17. Canadian Department of Communication statement

European Union EMC Directive Conformance statement

This product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximation of the laws of

the Member States relating to electromagnetic compatibility. Dell Networking can not accept responsibility for any failure to satisfy the

Specications