Service Manual

| | OUT-L2 ACL | 206 | 7 | 199
7 | 0 | IN-L3 ACL | 512 | 1 | 511
| | IN-V6 ACL | 0 | 0 | 0
| | IN-L2 ACL | 768 | 0 | 768
| | OUT-L3 ACL | 158 | 5 | 153
| | OUT-V6 ACL | 158 | 0 | 158
| | OUT-L2 ACL | 206 | 7 | 199
Codes: * - cam usage is above 90%.
Dell#
CAM Optimization
When you enable this command, if a Policy Map containing classication rules (ACL and/or dscp/ ip-precedence rules) is applied to
more than one physical interface on the same port-pipe, only a single copy of the policy is written (only 1 FP entry is used).
Troubleshoot CAM Proling
The following section describes CAM proling troubleshooting.
CAM Prole Mismatches
The CAM prole on all cards must match the system prole. In most cases, the system corrects mismatches by copying the correct
prole to the card, and rebooting the card. If three resets do not bring up the card, or if the system is running an Dell Networking OS
version prior to version 6.3.1.1, the system presents an error message. In this case, manually adjust the CAM conguration on the card
to match the system conguration.
Dell Networking recommends the following to prevent mismatches:
• Use the eg-default CAM prole in a chassis that has only EG Series line cards. If this prole is used in a chassis with non-EG line
cards, the non-EG line cards enter a problem state.
• Before moving a card to a new chassis, change the CAM prole on a card to match the new system prole.
• After installing a secondary RPM into a chassis, copy the running-conguration to the startup-conguration.
• Change to the default prole if downgrading to and Dell Networking OS version earlier than 6.3.1.1.
• Use the CONFIGURATION mode commands so that the prole is change throughout the system.
• Use the EXEC Privilege mode commands to match the prole of a component to the prole of the target system.
QoS CAM Region Limitation
To store QoS service policies, the default CAM prole allocates a partition within the IPv4Flow region.
If the QoS CAM space is exceeded, a message similar to the following displays.
%EX2YD:12 %DIFFSERV-2-DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3
Cam(PolicyQos) for class 2 (Te 1/20/1) entries on portpipe 1 for linecard 1
%EX2YD:12 %DIFFSERV-2-
DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3 Cam(PolicyQos) for class 5 (Te 1/
22) entries on portpipe 1 for linecard 1
If you exceed the QoS CAM space, follow these steps.
1. Verify that you have congured a CAM prole that allocates 24 K entries to the IPv4 system ow region.
2. Allocate more entries in the IPv4Flow region to QoS.
Dell Networking OS supports the ability to view the actual CAM usage before applying a service-policy. The test cam-usage
service-policy command provides this test framework. For more information, refer to Pre-Calculating Available QoS CAM
Space.
198
Content Addressable Memory (CAM)