Service Manual

The internal Priority assigned for the packet by Ingress FP is used by the memory management unit (MMU) to assign the packet to
right queue by indexing the internal-priority to queue map table (TABLE 1) in hardware.
PRIO2COS setting for honoring the PFC protocol packets from the Peer switches is as per above Packet-Dot1p->queue table (Table
2).
The packets that come in with packet-dot1p 2 alone will be assigned to PG6 on ingress.
The packets that come in with packet-dot1p 2 alone will use Q1 (as per dot1p to Queue classication – Table 2) on the egress port.
• When Peer sends a PFC message for Priority 2, based on above PRIO2COS table (TABLE 2), Queue 1 is halted.
• Queue 1 starts buering the packets with Dot1p 2. This causes PG6 buer counter to increase on the ingress, since P-dot1p 2 is
mapped to PG6.
• As the PG6 watermark threshold is reached, PFC will be generated for dot1p 2.
Conguration Example for DSCP and PFC Priorities
Consider a scenario in which the following DSCP and PFC priorities are necessary:
DSCP 0 – 5, 10 - 15 20 – 25, 30 – 35
Expected PFC
Priority
1 2
To congure the aforementioned DSCP and PFC priority values, perform the following tasks:
1. Create class-maps to group the DSCP subsets
class-map match-any dscp-pfc-1
match ip dscp 0-5,10-15
!
class-map match-any dscp-pfc-2
match ip dscp 20-25,30-35
2. Associate above class-maps to Queues Queue assignment to be based on the below table (This internal table has been
modied for S6000 platform) .
Table 14.
Internal-
priority
0 1 2 3 4 5 6 7
Queue 1 2 0 3 4 5 6 7
3. Dot1p->Queue Mapping Conguration is retained at the default value.
Default dot1p-queue mapping is,
Dell#show qos dot1p-queue-mapping
Dot1p Priority : 0 1 2 3 4 5 6 7
Queue :2 0 1 3 4 5 6 7
4. Interface Congurations on server connected ports.
a. Enable DCB globally.
Dell(conf)#dcb enable
b. Apply PFC Priority conguration. Congure priorities on which PFC is enabled.
Dell(conf-if-te-1/1/1)#pfc priority 1,2
Data Center Bridging (DCB)
227