Service Manual

INTERFACE PORT-CHANNEL mode
interface port-channel id number
3. Add the interface to the second port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
Example of Moving an Interface to a New Port Channel
The following example shows moving the TenGigabitEthernet 1/8/1 interface from port channel 4 to port channel 3.
Dell(conf-if-po-4)#show config
!
interface Port-channel 4
no ip address
channel-member TenGigabitEthernet 1/8/1
no shutdown
Dell(conf-if-po-4)#no chann tengi 1/8/1
Dell(conf-if-po-4)#int port 3
Dell(conf-if-po-3)#channel tengi 1/8/1
Dell(conf-if-po-3)#sho conf
!
interface Port-channel 3
no ip address
channel-member TenGigabitEthernet 1/8/1
shutdown
Dell(conf-if-po-3)#
Conguring the Minimum Oper Up Links in a Port Channel
You can congure the minimum links in a port channel (LAG) that must be in “oper up” status to consider the port channel to be in
“oper up” status.
To set the “oper up” status of your links, use the following command.
• Enter the number of links in a LAG that must be in “oper up” status.
INTERFACE mode
minimum-links number
The default is 1.
Example of Conguring the Minimum Oper Up Links in a Port Channel
Dell#config t
Dell(conf)#int po 1
Dell(conf-if-po-1)#minimum-links 5
Dell(conf-if-po-1)#
Conguring VLAN Tags for Member Interfaces
To congure and verify VLAN tags for individual members of a port channel, perform the following:
1. Congure VLAN membership on individual ports
INTERFACE mode
Dell(conf-if)#vlan tagged 2,3-4
2. Use the switchport command in INTERFACE mode to enable Layer 2 data transmissions through an individual interface
INTERFACE mode
Interfaces
337