Service Manual

Protocol Ethernet Address
PIM-SM 01:00:5e:00:00:0d
• The Dell Networking OS implementation of MTRACE is in accordance with IETF draft draft-fenner-traceroute-ipm.
• Multicast is not supported on secondary IP addresses.
• Egress L3 ACL is not applied to multicast data trac if you enable multicast routing.
Multicast Policies
Dell Networking OS oers parallel multicast features for IPv4.
• IPv4 Multicast Policies
IPv4 Multicast Policies
The following sections describe IPv4 multicast policies.
• Limiting the Number of Multicast Routes
• Preventing a Host from Joining a Group
• Preventing a PIM Router from Forming an Adjacency
• Preventing a Source from Registering with the RP
• Preventing a PIM Router from Processing a Join
Limiting the Number of Multicast Routes
When the total number of multicast routes on a system limit is reached, Dell Networking OS does not process any IGMP or multicast
listener discovery protocol (MLD) joins to PIM — though it still processes leave messages — until the number of entries decreases
below 95% of the limit.
When the limit falls below 95% after hitting the maximum, the system begins relearning route entries through IGMP, MLD, and
MSDP.
• If the limit is increased after it is reached, join subsequent join requests are accepted. In this case, increase the limit by at least
10% for IGMP and MLD to resume.
• If the limit is decreased after it is reached, Dell Networking OS does not clear the existing sessions. Entries are cleared after a
timeout (you may also clear entries using clear ip mroute).
NOTE: Dell Networking OS waits at least 30 seconds between stopping and starting IGMP join processing. You may
experience this delay when manipulating the limit after it is reached.
When the multicast route limit is reached, Dell Networking OS displays the following:
3w1d13h: %RPM0-P:RP2 %PIM-3-PIM_TIB_LIMIT: PIM TIB limit reached. No new routes will
be learnt until TIB level falls below low watermark.
3w1d13h: %RPM0-P:RP2 %PIM-3-PIM_TIB_LIMIT: PIM TIB below low watermark. Route learning
will begin.
To limit the number of multicast routes, use the following command.
• Limit the total number of multicast routes on the system.
CONFIGURATION mode
ip multicast-limit
The range if from 1 to 16000.
The default is 4000.
Multicast Features
515