Service Manual

Task Command Syntax Command Mode
AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv
sent: 43, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
10.1.1.100
Authentication: (none)
Conguring Management VRF
You can assign a management interface to a management VRF.
Task Command Syntax Command Mode
Create a management VRF.
ip vrf management
CONFIGURATION
Assign a management port to a
management VRF.
interface management
VRF MODE
Conguring a Static Route
To congure a static route, perform the following steps:
Task Command Syntax Command Mode
Congure a static route that points to a
management interface.
management route ip-address
mask managementethernet
ormanagement route ipv6-
address prefix-length
managementethernet
NOTE: You can also have the
management route to point to a
front-end port in case of the
management VRF. For example:
management route 2::/64 te 0/0.
CONFIGURATION
To congure a static entry in the IPv6 neighbor discovery, perform the following steps:
Task
Command Syntax Command Mode
Congure a static neighbor.
ipv6 neighbor vrf management
1::1 tengigabitethernet 1/1/1
xx:xx:xx:xx:xx:xx
CONFIGURATION
Sample VRF Conguration
The following conguration illustrates a typical VRF set-up.
850
Virtual Routing and Forwarding (VRF)