Setup Guide

NOTE: If you do not enter the allocation values for the CAM regions, the value is 0.
3 Execute write memory and verify that the new settings are written to the CAM on the next boot.
EXEC Privilege mode
show cam-acl
4 Reload the system.
EXEC Privilege mode
reload
Test CAM Usage
To determine whether sucient CAM space is available to enable a service-policy, use the test-cam-usage command. To verify the
actual CAM space required, create a Class Map with all required ACL rules, then execute the test cam-usage command in Privilege
mode. The Status column in the command output indicates whether or not you can enable the policy.
Example of the test cam-usage Command
DellEMC#test cam-usage service-policy input test-cam-usage stack-unit 1 po 0
Stack-Unit| Portpipe|CAM Partition|Available CAM|Estimated CAM per Port|Status
------------------------------------------------------------------------------------
2 | 0 |IPv4Flow |192 |3 |Allowed (64)
DellEMC#
View CAM Proles
To view the current CAM prole for the chassis and each component, use the show cam-profile command.
This command also shows the prole that is loaded after the next chassis or component reload.
Example of the show cam-profile Command
Dell#show cam-profile
-- Chassis CAM Profile --
CamSize : 18-Meg
: Current Settings : Next Boot
Profile Name : Default : Default
L2FIB : 32K entries : 32K entries
L2ACL : 1K entries : 1K entries
IPv4FIB : 256K entries : 256K entries
IPv4ACL : 12K entries : 12K entries
IPv4Flow : 24K entries : 24K entries
EgL2ACL : 1K entries : 1K entries
EgIPv4ACL : 1K entries : 1K entries
Reserved : 8K entries : 8K entries
FIB : 0 entries : 0 entries
ACL : 0 entries : 0 entries
Flow : 0 entries : 0 entries
EgACL : 0 entries : 0 entries
MicroCode Name : Default : Default
--More--
To view brief output of the show cam-profile command, use the summary option.
The show running-config cam-profile command shows the current prole and microcode.
NOTE
: If you select the CAM prole from CONFIGURATION mode, the output of this command does not reect any changes
until you save the running-conguration and reload the chassis.
Content Addressable Memory (CAM) 247