Setup Guide

User viewable Logs:
Logs for optic insertion and removal are same as QSFP optics. You can use the show inventory media command to check the optic
type and the show interface transceiver command to view the optic properties.
show inventory media
0 88 QSFP 4x1000BASE-T US0XJYD04162059 Yes
0 89 QSFP 4x1000BASE-T US0XJYD04162059 Yes
0 90 QSFP 4x1000BASE-T US0XJYD04162059 Yes
0 91 QSFP 4x1000BASE-T US0XJYD04162059 Yes
show interface transceiver
QSFP 0 Serial ID Base Fields
QSFP 0 Id = 0x0d
QSFP 0 Ext Id = 0x00
QSFP 0 Connector = 0x0c
QSFP 0 Transceiver Code = 0x04 0x00 0x00 0x00 0x00 0x00 0x00 0x00
QSFP 0 Encoding = 0x05
QSFP 0 Length(SFM) Km = 0x00
QSFP 0 Length(OM3) 2m = 0x32
QSFP 0 Length(OM2) 1m = 0x00
QSFP 0 Length(OM1) 1m = 0x00
QSFP 0 Length(Copper) 1m = 0x00
QSFP 0 Vendor Rev = 0
Overview of Layer Modes
On all systems running Dell EMC Networking OS, you can place physical interfaces, port channels, and VLANs in Layer 2 mode or Layer 3
mode.
By default, VLANs are in Layer 2 mode.
Table 42. Layer Modes
Type of Interface Possible Modes Requires Creation Default State
10 Gigabit Ethernet and 40
Gigabit Ethernet
Layer 2
Layer 3
No Shutdown (disabled)
Management N/A No Shutdown (disabled)
Loopback Layer 3 Yes No shutdown (enabled)
Null interface N/A No Enabled
Port Channel
Layer 2
Layer 3
Yes Shutdown (disabled)
VLAN
Layer 2
Layer 3
Yes, except for the default
VLAN.
No shutdown (active for Layer
2)
Shutdown (disabled for Layer 3 )
398 Interfaces