Setup Guide

To view the description for the IPv4 or IPv6 static routes, use the show running-config static command. Following is the sample
show running-config static output:
DellEMC#show running-config static
!
ipv6 route 1::/32 GigabitEthernet 2/3 11::1 name Stack-2
ipv6 route 2::/32 GigabitEthernet 2/48 11::1 name Stack-2
ip route 2.2.2.0/24 GigabitEthernet 2/47 name Stack-2
ipv6 route 1001:1001::/64 GigabitEthernet 1/42 2001:2001::1 name
ipv6_link_going_to_europe_centre
ip route 19.1.1.0/24 19.1.1.1 name This_link_goes_to_London_Central
ipv6 route 1500:1500::/96 2500:2500::1 name Under-Sea_Links_to_Asia-Pacific
ip route 50.50.1.32/30 Vlan 210 name AZ!#$_Link_to_Asia_$#
ip route 199.1.1.0 /24 vlan 100 name "Uplink To NewYork"
ip route 100.1.1.0/24 Vlan 100 name Any_Description_upto_32_characte
ip route 199.1.1.0/24 GigabitEthernet 1/41 name Added_Description_for_StaticRoute
NOTE: You can view the description of the congured static routes only using the show running-config static command.
Congure Static Routes for the Management
Interface
When an IP address that a protocol uses and a static management route exists for the same prex, the protocol route takes precedence
over the static management route.
To congure a static route for the management port, use the following command.
• Assign a static route to point to the management interface or forwarding router.
CONFIGURATION mode
management route ip-address mask {forwarding-router-address | ManagementEthernet slot/port}
Example of the show ip management-route Command
To view the congured static routes for the management port, use the show ip management-route command in EXEC privilege
mode.
DellEMC#show ip management-route
Destination Gateway State Route Source
----------- ------- ----- ------------
10.16.0.0/16 ManagementEthernet 1/1 Connected Connected
172.16.1.0/24 10.16.151.4 Active Static
Using the Congured Source IP Address in ICMP
Messages
ICMP error or unreachable messages are now sent with the congured IP address of the source interface instead of the front-end port IP
address as the source IP address. Enable the generation of ICMP unreachable messages through the ip unreachable command in
Interface mode. When a ping or traceroute packet from an endpoint or a device arrives at the null 0 interface congured with a static route,
it is discarded. In such cases, you can congure Internet Control Message Protocol (ICMP) unreachable messages to be sent to the
transmitting device.
Conguring the ICMP Source Interface
You can enable the ICMP error and unreachable messages to contain the congured IP address of the source device instead of the
previous hop's IP address. This conguration helps identify the devices along the path because the DNS server maps the loopback IP
address to the host name, and does not translate the IP address of every interface of the switch to the host name.
IPv4 Routing
443