Users Guide

Usage
Information
The monitor command is saved in the running configuration at Monitor Session mode level and can be
restored after a chassis reload.
Example
Dell# show monitor session
SessID Source Destination Dir Mode Source IP Dest IP
DSCP TTL
------ ------ ----------- --- ---- --------- --------
---- ---
0 Te 1/12/1 remote-ip rx Flow 1.1.1.1 7.1.1.2
0 255
0 Po 1 remote-ip tx Flow 1.1.1.1 7.1.1.2
0 255
1 Vl 11 remote-ip rx Flow 5.1.1.1 3.1.1.2
0 255
Related
Command
● show monitor session — displays the monitor session.
● show running-config monitor session — displays the running configuration of a monitor session.
rate-limit
Configure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit Enter the rate-limit value. The range is from 0 to 40000 Megabits per second.
Defaults 60
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, Z9500.
Related
Commands
● monitor session — enable a monitoring session.
● show monitor session — display the monitor session.
show config
Display the current monitor session configuration.
Syntax
show config
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
Port Monitoring 1005