Users Guide

Related
Commands
● ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.
distribute-list out
Configure a filter for outgoing routing updates.
S6000–ON
Syntax
distribute-list prefix-list-name out [interface | bgp | connected | isis |
ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Identifies the interface type slot/port as one of the following:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
connected (OPTIONAL) Enter the keyword connected to filter only directly connected
routes.
isis (OPTIONAL) Enter the keyword isis to filter only IS-IS routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually configured routes.
Defaults Not configured.
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
Routing Information Protocol (RIP) 1087