Users Guide

Dell(conf-if-te-1/4/2)#
Dell(conf-if-te-1/4/2)# show config
!
interface TenGigabitEthernet 1/4/2
ip vrf forwarding red
ip address 100.1.1.1/24
no shutdown
Dell(conf-if-te-1/4/2)#
ip http vrf
Configure an HTTP client with a VRF used to connect to the HTTP server.
S6000–ON
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client configuration, use the ip http vrf command.
Parameters
management Enter the keyword management for configuring the management VRF that uses
an HTTP client.
vrf-name Enter a VRF name that the HTTP client uses. If you do not specify a VRF name, the
HTTP client uses the default VRF.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9500.
Usage
Information
To make the HTTP clients VRF-aware, use the ip http vrf command. The HTTP client uses the VRF
name that you specify to reach the HTTP server. If you do not specify a VRF name, the HTTP client uses
the default VRF.
ip route-export
Enables route leaking between VRFs. This command exports or shares IPv4 routes corresponding to one VRF with other
nondefault VRFs.
Syntax
ip route-export tag [route-map-name]
Parameters
route-export Enter the keywords route-export to leak or share routes between VRFs.
tag Enter a tag (export route target) to expose routes to other VRFs. This tag acts as
an identifier for exported routes. Use this identifier while importing these routes
into another nondefault VRF.
route-map-name (Optional) Enter the name of the route-map to filter the exported routes.
Virtual Routing and Forwarding (VRF) 1359