Users Guide

The platform supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
deny
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}} [no-drop]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no deny {source [mask] | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the
packet was sent.
any Enter the keyword any to specify that all routes are subject to the filter. You can
enter any of the following keywords to specify route types.
● bytes — Enter the keyword count to count packets the filter processes.
● count — Enter the keyword bytesorder to count bytes the filter processes.
● dscp — Enter the keyword dcsp followed by the DCSP value to match to the
IP DCSCP values. The range is from 0 to 63.
● fragments — Enter the keyword fragments to use ACLs to control packet
fragments.
● order — Enter the keyword order to specify the QoS order of priority for
the ACL entry. The range is from 0 to 254 (0 is the highest priority and 254 is
the lowest; lower-order numbers have a higher priority). The default is, if you do
not use the keyword order, the ACLs have the lowest order by default (255).
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address
only.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Access Control Lists (ACL) 165