Users Guide

show feature
Verify the status of software applications, such as VRF, that are activated and running on a device.
Syntax
show feature
Command Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.4(0.0) Introduced on the S4810, S4820T, and S6000.
Usage
Information
You can activate VRF application on a device by using the feature vrf command in CONFIGURATION
mode. The no feature vrf command is not supported on any of the platforms.
Example
Dell# show feature
Feature State
------------------------------
VRF Enabled
Dell#
Command Modes
To navigate and launch various CLI modes, use specific commands. Navigation to these modes is described in the following
sections.
BGP ADDRESS-FAMILY Mode
To enable or configure IPv4 for BGP, use BGP ADDRESS-FAMILY mode. For more information, see Border Gateway Protocol
IPv4 (BGPv4).
To enter BGP ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER BGP mode.
2. Enter the address-family command.
3. Enter the protocol type:
● For IPv4, enter the ipv4 multicast command. The prompt changes to include conf-router_bgp_af for IPv4.
CLASS-MAP Mode
To create or configure a class map, use CLASS-MAP mode. For more information, see Policy-Based QoS Commands.
To enter CLASS-MAP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the class-map command, and then enter the class map name. The prompt changes to include config-class-
map.
You can return to CONFIGURATION mode by using the exit command.
CLI Basics
43