Users Guide

Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP address to the
Management port, use the ip address command.
Example
Dell(conf)# interface managementethernet 1/1
Dell(conf-if-ma-1/1)#
Related
Commands
● management route — configure a static route that points to the Management interface or a
forwarding router.
● speed (Management interface) — Set the speed for the Management interface.
interface null
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
You cannot delete the Null interface. The only configuration command possible in a Null interface is ip
unreachables.
Example
Dell(conf)# interface null 0
Dell(conf-if-nu-0)#
Related
Commands
● interface — configure a physical interface.
● interface loopback — configure a Loopback interface.
● interface port-channel — configure a port channel.
Interfaces 565