Users Guide

Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto, Mode auto
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 3w0d17h
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
5144 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 3w0d17h
GigabitEthernet 1/1/2 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:4c:f2:83
Current address is 00:01:e8:4c:f2:83
!-------------output truncated ----------------!
Related
Commands
● show hardware stack-unit — display data plane and management plane input/output statistics.
● show interfaces — display information on a specific physical interface or virtual interface.
show interfaces status
To display status information on a specific interface only, display a summary of interface information or specify a stack-unit slot
and interface.
Syntax
show interfaces [interface | stack—unit slot-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords the interface information:
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
NOTE: This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation for
specifying port range in the command is different from how you specify in non-
ON platforms.
● For non-ON platforms, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces interface-
type 1/1 - 4.
● For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
stack-unit slot-
number
(OPTIONAL) Enter the keyword stack-unit then the slot number. The range is
from 0 to 5.
Interfaces 591