Users Guide

To return to the default setting, use the no speed command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 100 Mb/s.
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate its speed.
Defaults auto
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
● interface ManagementEthernet — configure the Management port on the system (either the Primary
or Standby RPM).
● duplex (10/100 Interfaces) — configure duplex mode on physical interfaces with the speed set to
10/100.
● management route — configure a static route that points to the Management interface or a
forwarding router.
stack-unit portmode
Split a single 40G port into four 10G ports.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset.
number Enter the port number of the port to be split. The total number of ports are 32. The
range is from 1 to 32.
Defaults Disabled.
Command Modes CONFIGURATION
Interfaces 605