Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage
Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to display flows
for switched Layer 2 packets, not for routed packets (use the show ip flow command to display
routed packets).
The show port-channel-flow command returns the egress port identification in a given port-
channel if a valid flow is entered. A mismatched flow error occurs if MAC-based hashing is configured for
a Layer 2 interface and you are trying to display a Layer 3 flow.
The output displays three entries:
● Egress port for unfragmented packets.
● In the event of fragmented packets, the egress port of the first fragment.
● In the event of fragmented packets, the egress port of the subsequent fragments.
NOTE: In the show port channel flow command output, the egress port for an unknown
unicast, multicast, or broadcast traffic is not displayed.
The following example shows the show port-channel-flow outgoing-port-channel number
incoming-interface interface source-mac address destination-mac address
● Load-balance is configured for MAC
● Load-balance is configured for IP 4-tuple/2-tuple
● A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address
Example
Dell# show port-channel-flow outgoing-port-channel 1 incoming-interface
te 1/1/3
source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00
Egress Port for port-channel 1, for the given flow, is Te 1/2/2
ip http source-interface
Specify an interface as the source interface for HTTP connections.
Syntax
ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Interfaces 617