Users Guide

warning-only When the warning-only option is used, a syslog message will be thrown when
maximum number of dynamic IPv6 routes reaches the limit. Additional dynamic IPv6
routes will still be allowed.
Defaults No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command Modes
CONFIGURATION-VRF
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, and Z9500.
Usage
Information
If the maximum IPv6 route limit is not specified for a VRF (valid range is from 1 to 8000), then it has
unlimited space that extends to the maximum number of entries allowed for the system. This command is
not applicable to the default and management VRFs.
show cam-ipv6 extended-prefix
Display the current settings and next-boot settings for cam-ipv6 extended-prefix configuration. Display the cam-ipv6 extended-
prefix configuration.
Syntax
show cam-ipv6 extended-prefix
Defaults None
Command Modes
EXEC
EXEC Privilege
Command
History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S6000.
Usage
Information
You can use this command to view the number of supported extended prefix entries in LPM configured.
The output also displays the current applied value and the new value that is applicable after the reboot of
the device.
Example
Dell# show cam-ipv6 extended-prefix
Cam-Ipv6-LPM Extended Prefix
--------------------------------
Current Settings
cam-ipv6-max-/65-to-/128-Prefix : 2048
Dell(conf)#
680 IPv6 Basics